A German-made reciprocating triplex plunger pump for high temperature applications.
Spheroidal cast iron crankcase with vented dipstick; forged, through-hardened, ground and polished crankshaft; bronze connecting rods; hardened stainless steel plunger bases; solid ceramic plungers; high temperature nitrile seals (with fabric reinforcing); stainless steel valves and cast bronze manifold with coolant tube connections.
WARNING: This product might contain a chemical known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
|Flow||25.1 GPM||95.0 L/min|
|Flow||1,506 GPH||5,700 L/hr|
|Maximum Discharge Pressure||1160 PSI||80 bar|
|Crankshaft Speed||460 RPM|
|Inlet Ports||(2) 2-1/2″ BSP|
|Discharge Ports||(2) 1-1/4″ BSP|
|Weight||375 lbs.||170 kg|
|Key Component Material|
|Plungers||Solid Ceramic Oxide|
|Seals||High Temp Seals|
|Gear End||Spheroidal Cast Iron|
The ratings shown are the power requirements for the pump. Gas engine power outputs must be approximately twice the pump power requirements shown above.
We recommend a 1.15 service factor be specified when selecting an electric motor as the power source. To compute specific pump horsepower requirements use the following formulas:
Electric HP = (GPM X PSI)/1450
Gas HP = (GPM X PSI)/1100
*Engine power varies based on horizontal or vertical orientation, as well as by makes and models from each manufacturer.
|Plunger Packing Kit – Part #09804|
|Oil Seal Kit – Part #09221|
|32||07624||Radial Shaft Seal||3|
|Valve Repair Kit – Part #09806|
Repair Kits Available
The repair kits listed to the right are available for this pump. If you need further information about these repair kits, or have questions about other specific parts for your pump, please contact you local Giant distributor or contact Giant customer service.