A German-made reciprocating triplex plunger pump.
Spheroidal cast iron crankcase with sight glass and vented dipstick; forged, through-hardened, ground and polished crankshaft; bronze connecting rods; hardened stainless steel plunger bases; zirconia oxide ceramic plungers; aramid packing; stainless steel valves; machined stainless steel manifold and piping for cooling the seals.
WARNING: This product might contain a chemical known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov
|Flow||4.6 GPM||17.5 L/min|
|Maximum Discharge Pressure||11,600 PSI||800 bar|
|Crankshaft Speed||1000 RPM|
|Maximum Inlet Pressure||145 PSI||10 bar|
|Maximum Temperature||104 °F||40 °C|
|Plunger Diameter||0.55″||14 mm|
|Crankshaft Diameter||1.38″||35 mm|
|Crankshaft Rotation||Top of Pulley Towards Manifold|
|Key Width||0.38″||10 mm|
|Crankshaft Mounting||Either Side|
|Inlet Ports||(2) 1/2″ BSP|
|Discharge Ports||(2) 1/2″ BSP|
|Crankcase Oil Capacity||0.92 Gal||3.5 L|
|Weight||115 lbs.||52 kg|
|Key Component Material|
|Manifold||Machined Stainless Steel|
|Plungers||Zirconia Oxide Ceramic|
|Gear End||Spheroidal Cast Iron|
|RPM||GPM||5000 PSI||7250 PSI||10,000 PSI||11,600 PSI|
The ratings shown are the power requirements for the pump. Gas engine power outputs must be approximately twice the pump power requirements shown above.
We recommend a 1.15 service factor be specified when selecting an electric motor as the power source. To compute specific pump horsepower requirements use the following formulas:
Electric HP = (GPM X PSI)/1450
Gas HP = (GPM X PSI)/1100
*Engine power varies based on horizontal or vertical orientation, as well as by makes and models from each manufacturer.
|Plunger Packing Kit – Part #09618|
|38||05366||Sleeve Support Ring||3|
|43||06595||Border Seal Ring||3|
|Valve Assembly Kit – Part #09518|
|49||06598||Inlet Valve Plate||3|
|52||06600||Support Ring for O-Ring||3|
|53||06601||Border Seal Ring||3|
|57||06604||Discharge Valve Plate||3|
|Oil Seal Kit – Part #09577|
Repair Kits Available
The repair kits listed to the right are available for this pump. If you need further information about these repair kits, or have questions about other specific parts for your pump, please contact you local Giant distributor or contact Giant customer service.