CGP7163

A uniquely designed triplex plunger pump that is capable of pumping both liquid CO2 and gaseous CO2.  The compressor pumps gaseous CO2 from a pressurized chamber back to a storage tank.

WARNING: This product might contain a chemical known to the State of California to cause cancer, and birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov

  • CGP7163 Exploded View
  • CGP7163 Parts List
  • CGP7163 Torque Specifications

Sorry, there are no accessories associated with this product.

  • Giant Industries Limited Warranty
  • CGP7163 Installation Instructions
  • CGP7163 Repair Instructions
  • Troubleshooting Guide

SPECIFICATIONS

U.S. Metric
Flow 59.3 GPM 224.4 L/min
Discharge Pressure 1160 PSI 80 bar
Crankshaft Speed 480 RPM
Maximum Inlet Pressure 870 PSI 60 bar
Temperature of Pumped Fluids -40 ºF to 140 ºF -40 ºC to 60 ºC
Crankshaft Diameter 1.89″ 48 mm
Crankshaft Rotation Top of Pulley Towards Manifold
Key Width 0.55″ 14 mm
Crankshaft Mounting Either Side
Inlet Ports 1-1/2″ BSP
Discharge Ports 1″ BSP
Crankcase Oil Capacity 1.6 Gal 6.0 L
Key Component Material
Manifold Special Brass
Plungers Solid Ceramic Oxide
Valves High Grade Stainless Steel
Seals Nitrile With Fabric Reinforcing
Gear End Spheroidal Cast Iron

Click the image to enlarge


HORSEPOWER SPECIFICATIONS

Contact Giant Industries for Horsepower Information

Horsepower Requirements

The ratings shown are the power requirements for the pump. Gas engine power outputs must be approximately twice the pump power requirements shown above.

We recommend a 1.15 service factor be specified when selecting an electric motor as the power source. To compute specific pump horsepower requirements use the following formulas:
Electric HP = (GPM X PSI)/1450
Gas HP = (GPM X PSI)/1100


*Engine power varies based on horizontal or vertical orientation, as well as by makes and models from each manufacturer.


REPAIR KITS

ITEM# PART# DESCRIPTION Qty.
Fluid End Repair Kit – Part #CP09831
37 CP03143 O-Ring 3
40 CP03144 Two-Part Rod Seal 6
43 CP03146 Driving Ring 6
44 CP03147 Seal Packing 3
50 CP03148 O-Ring 9
54 CP03149 O-Ring 3
55 CP06817 O-Ring 3
57 CP03161 O-Ring 6
Valve Assembly Kit – Part #CP09832
47 CP03155 Suction Valve Plate 3
57 CP03161 O-Ring 6
58 CP03162 Discharge Valve Plate 3
59 CP07732-0100 Valve Spring 3
Oil Seal Kit – Part #CP09577/09612
32 CP07624 Radial Shaft Seal 3
33A CP13286 O-Ring 3

Repair Kits Available

The repair kits listed to the right are available for this pump. If you need further information about these repair kits, or have questions about other specific parts for your pump, please contact you local Giant distributor or contact Giant customer service.

PUMP CATEGORIES:
Service & Repair

Giant provides service on each pump and accessory that we sell. Many basic repair procedures are covered in the Giant repair manual. For all other questions on service or repair needs please contact your local Giant distributor.